This is the dry fit of the two rafters. It took a little adjusting to make them fit well together. It's a friction fit to the members. The roof is a 12 on 12 pitch.
This is the fork all cut and the missing piece is due to getting to close to the edge of the member. 2" void should be cut out to make the other tong fit into the fork. We used a 2" block to test the width.
This is going to be the fork of the rafter, we found the center of the 6x6 then went a inch in each directions. Then went back the thickness of the member that's butting into this 6x6.
No comments:
Post a Comment